That will present you with a list of inputs. The trick is to have the USB output channels on the DAW set to the same corresponding USB inputs set on the Input block of the Helix.ītw, if the problem is finding the input choices on the Helix Input block, just select the Input block and push the joystick down. When you hit playback on your DAW you should now hear the dry track you recorded coming back in through the Helix. Now go to the Helix Input block, scroll down and set the Helix Input block to "USB 3/4". Now you can set the output on your DAW for example to USB 3/4. That will be your dry track from the Helix. Now arm and record whatever tracks on your DAW you wish to record, for example USB 1/2 for the wet effected mix from the Helix and also record a track that uses USB 7 as the input. This will send your dry guitar signal from the Helix's "Guitar" input out to the DAW on USB 7. You can configure the source on the Helix setting the 'Global Settings' -> INs/Outs -> 'Re-amp Src (USB 7) = "Guitar" for example. Thank you very much in advance for being as precise as possibleīy default the Helix will output a dry signal for whatever sources you choose on the USB 7 and USB 8 outputs. I am really new to reamping and not that fluent at the whole recording process, but everything was quite straightforward when using reaper so far but now I kinda feel lost. The recorded guitar track should now be sent via the re-amp box to your amp.I'm a bit confused, I have read a few threads on this very topic and still can't find the way to changing the dry track input to USB7.īoth tracks (stereo and mono) are created, armed for recording.Ĭan someone describe me precisely where to find the path to setup the input to USB7 ? I have been looking for it everywhere (under the "input" section below the track's name, under the "in"section as well).
0 Comments
Leave a Reply. |